Chapter 3 Preparatory Work - Zte ZXHN H268A Maintenance Management Manual

Chapter 3
Preparatory Work
This manual uses the Windows operating system as an example for describing how to log
in to open the ZXHN H268A.
Context
To log in to open the ZXHN H268A on a computer, you need to set the IP address of the
computer to ensure that the IP address of the computer and the maintenance IP address
of the ZXHN H268A are in the same network segment.
The default maintenance information of the ZXHN H268A is as follows:
l
IP address: 192.168.20.1
l
Subnet mask: 255.255.255.0
l Gateway: 192.168.20.1
Steps
1. Use an Ethernet cable to connect a local computer to open the LAN interface of the
ZXHN H268A.
2. Use an telephone line to connect the ZXHN H268A with the VDSL cable or splitter.
3. On the local computer, double-click Local Area Connection and click Properties.
The Local Area Connection Properties dialog box is displayed.
4. Double-click Internet Protocol (TCP/IP). The Internet Protocol (TCP/IP) Properties
dialog box is displayed. Set the IP address to 192.168.20.200, subnet mask to
255.255.255.0, and default gateway to 192.168.20.1.
5. Click OK.
6. After the IP address of the computer is set, you can run the Ping command to ping
the IP address 192.168.20.1. If the ping operation is successful, it indicates that the
TCP/IP configuration is correct and the computer is properly connected to open the
ZXHN H268A, as shown in
SJ-20150916162339-007|2017-02-16 (R1.0)
Figure 3-1.
3-1
ZTE Proprietary and Confidential