Connecting Cables - Motorola Avigilon H5A Series Installation Manual

4. Insert the sealing grommet with the required cables pulled through into the cable entry hole on the
bottom of the camera. For more information on using the sealing grommet, see
through the Sealing Grommet on
5. Mount the camera to the wall plate using the wall plate mounting screws.

Connecting Cables

Refer to the diagrams in
1. If external input or output devices are part of the installation (for example: door contacts, relays, etc.),
connect the devices to the I/O connector block.
2. If an external microphone needs to be connected to the camera, connect the device to the camera
A/V connector.
For more information, see
3. (2.0 megapixel models only) If an external video monitor needs to be connected to the camera,
connect the device to the camera A/V connector.
For more information, see
4. Connect a network cable to the Ethernet port (RJ-45 connector).
The Link LED indicator will turn on once a network link has been established.
5. Connect power using one of the following methods:
Power over Ethernet (PoE) Class 3 — If PoE is available, the LEDs will turn on.
o
External Power — Connect an external 12 V DC or 24 V AC power source to the power
o
connector block.
6. Check that the Connection Status LED indicator indicates the correct state. For more information, see
Connection Status LED Indicator on
Connecting Cables
page 20.
Overview on page 1 for the location of the different connectors.
Connecting to Microphones, Speakers, and Video Monitors on
Connecting to Microphones, Speakers, and Video Monitors on
page 55.
Inserting Cables
page 53.
page 53.
37