1. Remove the sealing grommet from the camera.
2. Pull the tab on the grommet to open a hole for the Ethernet cable.
3. Push an Ethernet cable through the grommet by one of the following methods:
a. If the Ethernet cable is uncrimped, push the cable through the grommet.
b. If the Ethernet cable is already crimped, place the grommet piercing cap on the Ethernet
connector then push the cable through the grommet.
Ensure that the orientation of the cable and grommet matches the one shown in the image.
4. Push any other required cables through the grommet.
Note: If you will pull multiple cables through the sealing grommet, apply silicone sealant to
seal any gaps in the grommet.
Inserting Cables through the Sealing Grommet
21