Table of Contents
Advertisement
To detach a lens, complete the following steps:
1. Disconnect power from the camera.
2. While pressing the lens release button, turn the lens counterclockwise until it stops.
3. Remove the lens from the camera. Immediately mount another lens or a dust cap on the lens mount
to prevent contamination.
CAUTION —
Never touch the image sensor or any glass elements inside the lens mount. Only clean the
l
image sensor with the recommended cleaning tools.
Do not allow dust, moisture or any other foreign debris to enter the lens mount.
l
Avoid leaving the image sensor exposed for extended periods of time.
l
Always cover the image sensor with either a lens or a dust cap.
l
Mounting the Camera
1. Use the ¼"-20 UNC threaded holes to mount the camera on to a bracket, tripod or in an enclosure as
required.
Mount the camera using the tripod collar on the lens.
o
If the lens does not have a tripod collar, use the threaded hole at the bottom of the camera.
o
Consult the installation instructions provided with the bracket, tripod or enclosure for detailed mounting
instructions.
CAUTION — Always mount the camera from the lens tripod collar when the lens includes a collar.
The camera shall be mounted horizontally or with the lens pointed downwards.
WARNING — Use only UL-listed mounting bracket suitable for the mounting surface and minimum
0.4 kg (0.9 lb) weight plus the weight of the attached lens.
Connecting Cables
Refer to the diagrams in the image below or see
connectors.
Mounting the Camera
Overview on page 1
for the location of the different
6
Advertisement
Table of Contents
