Connecting Cables - Motorola Avigilon H4 Series Installation Manual

1. Attach a conduit connector to the cable entry hole on the back panel. Install the conduit and its fitting
as instructed by the manufacturer.
2. Pull the required cables through the conduit, then through the cable entry hole in the back panel.
Figure 1: Cables going through the conduit connector (1) and the back panel (2).
3. After you make the cable connections, screw the back panel into place.

Connecting Cables

Refer to the diagrams in the Overview section for the location of the different connectors.
To connect the cables required for proper operation, complete the following:
1. If external input or output devices are part of the installation (for example: door contacts, relays, etc.),
connect the devices to the I/O connector block.
2. If an external microphone or external video monitor needs to be connected to the camera, connect
the devices to the camera Audio/Video Connector.
3. Connect power using one of the following methods:
Power over Ethernet (PoE) Plus IEEE 802.3at Class 4 — Connect a PoE Plus compliant injector
l
or switch to the Ethernet network cable.
External Power — Connect an external "Class 2" or "LPS" or "Limited Power Source" with
l
output rated 24 VAC +/- 10%, 32 VA minimum or 24 VDC +/- 10%, 23 W minimum.
Connecting Cables 8