Danfoss AKD 2800 Quick Setup Manual page 16

Description of choice:
See parameter 009 Large display readout.
012 Small display readout 1.3
(DISPLAY LINE 1.3)
Value:
See parameter 009 Large display readout
Function:
See the functional description given under parameter
010 Small display readout.
Description of choice:
See parameter 009 Large display readout.
013 Local control
(LOC CTRL/CONFIG.)
Value:
Local not active (DISABLE)
Local control and open loop
(LOC CTRL/OPEN LOOP)
Remote-operated control and open loop
( LOC+DIG CTRL)
Local control as parameter 100
(LOC CTRL/AS P100)
Remote-operated control as parameter 100
( LOC+DIG CTRL/AS P100)
Function:
This is where the required function is selected if,
in parameter 002 Local/remote operation, Local
operation [1] has been chosen.
Description of choice:
If Local not active [0] is selected, it is not possible to
set a reference via parameter 003 Local reference.
In order to enable a shift to Local not active [0],
parameter 002 Local/remote operation must be
set to Remote operation [0].
Local control and open loop [1] is used if the motor
speed is to be set via parameter 003 Local reference.
When this choice is made, parameter 100 Configuration
automatically shifts to Speed regulation, open loop [0].
Remote-operated control and open loop [2] functions
in the same way as Local control and open loop
[1]; however, the frequency converter can also
be controlled via the digital inputs.
= factory setting. () = display text [] = value for use in communication via serial communication port
16
AKD 2800
Local control as parameter 100 [3] is used when the
motor speed is to be set via parameter 003 Local
reference, but without parameter 100 Configuration
automatically shifting to Speed regulation, open loop [0].
Remote-operated control as parameter 100 [4]
works the same way as Local control as parameter
100 [3]; however, the frequency converter can also
be controlled via the digital inputs.
Power [kW][8]
Shifting from Remote operation to Local operation
in parameter 002 Local/remote operation, while this
parameter has been set to Remote-operated control
and open loop [1]: The present motor frequency and
direction of rotation will be maintained. If the present
direction of rotation does not respond to the reversing
signal (negative reference), the reference will be set to 0.
Shifting from Local operation to Remote operation
in parameter 002 Local/remote control, while
this parameter has been set to Remote-operated
control and open loop [1]: The configuration
selected in parameter 100 Configuration will be
[0]
active. The shift will be smooth.
[1] Shifting from Remote control to Local control in
parameter 002 Local/remote operation, while this
[2] parameter has been set to Remote-operated control
as parameter 100 [4]: the present reference will
[3] be maintained. If the reference signal is negative,
the local reference will be set to 0.
[4]
Shifting from Local operation to Remote operation
in parameter 002 Local/remote operation, while
this parameter has been set to Remote operation:
The local reference will be replaced by the
remote-operated reference signal.
014 Local stop
Value:
Not active (DISABLE)
Active (ENABLE)
Function:
In this parameter, the local [STOP]-key can be
engaged or disengaged on the control panel
and on the LCP control panel.
Description of choice:
If Not active [0] is selected in this parameter,
the [STOP]-key will be inactive.
(LOCAL STOP)
[0 ]
[1]
MG.28.H2.02 -