Reference Information; Specification - GARDASOFT RT Series User Manual

13

Reference information

13.1

Specification

Each output channel
Lighting rating
Operating modes
Trigger input
Pulse width:
(RT2xx, RT4xx )
Pulse width:
(RT2xxF, RT4xxF RT8xxF)
Trigger delay:
(RT2xx, RT4xx )
Trigger delay:
(RT2xxF, RT4xxF RT8xxF)
Internal trigger timer
Supply voltage
Heat dissipation
WWW.STEMMER-IMAGING.COM
This section contains the specification for the RTxxx and any restrictions
on its use. Error and event codes are also listed.
The RTxxx range of controllers has a 2 amp option with a '-2' suffix, and a
fast pulsing option with an 'F' suffix. The specification for these is shown
below alongside standard versions.
3A maximum continuous /
20A pulsed, 46V output and
30W average output power*
12V to 36V in steps of 1V
100mA to 3A in steps of 5mA
Opto-isolated, standard or inverted operation
20 microseconds to 1 second. Repeatable to
20 microseconds to 1 second. Repeatable to
2 microseconds to 1 second. Repeatable to
*Refer to Section 13.2, Restrictions
RTxxx LED lighting controllers - User Manual
RTxxx-20
Continuous, strobe, switch, and selected
3V to 24V
0.1 microseconds.
1 microsecond to 1 second. Repeatable to
0.1 microseconds.
2 microseconds.
2 microseconds.
0.2Hz to 1kHz
24VDC to 48VDC regulated
10W maximum
— 62 —
RTxxx-2
2A maximum continuous /
2A pulsed, 46V output and
30W average output power*
12V to 36V in steps of 1V
100mA to 2A in steps of 1mA