OPERATING THE PATIENT LIFT
Secondary Emergency Release
NOTE: For this procedure, refer to FIGURE 3.3.
NOTE: Use the primary emergency release
first. The secondary emergency release is only a
back‐up to the primary emergency release.
In cases where the primary release is either
not functioning or unreachable, a
secondary emergency release may be used.
To activate the secondary release, pull up
on the EMERGENCY ring and push down
on the boom at the same time.
Performing an Emergency Stop
NOTE: For this procedure, refer to FIGURE 3.4.
Press the RED/ORANGE emergency button on the control box to stop the boom assembly
and patient from raising or lowering.
Rotate the RED/ORANGE emergency stop button clockwise to disengage the emergency
stop.
Control Box
Press IN to
Stop Boom
Charging the Battery
NOTE: For this procedure, refer to FIGURE 3.5 on page 25.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1. Lift up on the handle on the back of the battery.
2. Lift the battery up and out of the control box.
Electric Portable Patient Lift
FIGURE 3.4 Performing an Emergency Stop
FIGURE 3.3 Secondary Emergency Release
Rotate CLOCKWISE to
Disengage Emergency Stop
24
Push DOWN
on Boom
Pull UP on
EMERGENCY
Ring
Part No. 1145810