Assembling The Boom Actuator - Invacare Low Profile RPL450-2 Owner's Operator And Maintenance Manual

INSTALLATION

Assembling the Boom Actuator

NOTE: For this procedure, refer to FIGURE 2.3.
1. Remove the shoulder bolt, washer and
nut from the mounting bracket on the
boom assembly.
2. Unpack the pinch guard from the
patient lift carton.
NOTE: The bottom of the boom actuator
assembly will already be assembled to the mast
mounting bracket.
3. Cut the plastic‐wrap that secures the
boom and mast together.
4. Lift‐up on the boom and place it on
your left shoulder.
5. Let the boom actuator rest on shoulder
and rotate the shaft extension of the
actuator assembly until it lines‐up with
the mounting holes in the boom
assembly.
6. Place the pinch guard over the shaft extension of the boom actuator.
Electric Portable Patient Lift
Caster Lock
FIGURE 2.2 Assembling Mast to Base
18
U-Shaped
Base
Cut-Out
Shoulder Bolt
Boom Assembly
Boom Actuator
Boom Actuator
Mast Mounting
Bracket
FIGURE 2.3 Assembling the Boom
Actuator
Mast
Shoulder
Bolt
Mounting Bracket
Washer
Nut
Shaft Extension
Pinch Guard
NOTE: Turn 90°
Part No. 1145810