Configure A Single Switch In The X400 Appliance; Single Switch Configuration In The X400 Appliance - Dell EMC PowerProtect X400 Hardware Configuration And Installation Manual

Configure a single switch in the X400 Appliance

1
1
Internal VLAN ports
(within appliance)
Node 3
1
Node 4
1
Internal network port
External network port
All 3 ports both on the X400 platform cube and the X400 capacity cubes should be
l
connected to the internal VLAN on switch 2.
The following figure illustrates a single Dell S4128F (28 x 10G SFP+ ports) top-of-rack
switch which does not provide network redundancy. (Note that any type of switch can
be used, as long as it is a 10 GbE or greater SFP+ switch that supports VLAN.) Follow
the same pattern for connecting X400 capacity cube nodes 3 and 4.
Figure 32 Single switch configuration in the X400 Appliance
0
2
0
2
2 3
0
2 3
0
PowerProtect X400 Appliance Hardware Configuration and Installation Guide
3
3
X400 capacity cube Node 2
X400 capacity cube Node 1
Follow the pattern for
capacity cube nodes 3 and 4
2 3
1 0
2 3
1 0
X400 platform cube
Configure switches
Node 1
Node 2
43