Configure Two Switches In The X400 Appliance; Dual Switch Configuration In The X400 Appliance - Dell EMC PowerProtect X400 Hardware Configuration And Installation Manual

Configure switches

Configure two switches in the X400 Appliance

1
1
Internal VLAN ports
(within appliance)
Node 3
1
Node 4
1
Internal network port
External network port
PowerProtect X400 Appliance Hardware Configuration and Installation Guide
40
The following figure illustrates two Dell S4048F (48 x 10G SFP+ ports) top-of-rack
switches for network redundancy. (Note that you can use any type of switch, as long
as it is an SFP+ switch that supports 10 GbE or 25 GbE and VLAN.) For the most
reliable redundancy and balancing, the external (public) ports from each NIC should go
to separate switches, and the internal (private) ports from each NIC should go to
separate switches.
Figure 30 Dual switch configuration in the X400 Appliance
0
2
0
2
2 3
0
2 3
0
3
3
Follow the pattern for capacity cube nodes 3 and 4
X400 capacity cube Node 2
X400 capacity cube Node 1
X400 platform cube
2 3
1 0
2 3
1 0
Node 1
Node 2