Install The X400 Platform Cube In The Rack; Installing The Static Rail - Dell EMC PowerProtect X400 Hardware Configuration And Installation Manual

Install the X400 platform cube in the rack

Figure 27 Installing the static rail
1. Rack flange
2. Release latch (2)
3. Support bracket
4. Rail peg (4)
This procedure is used to install the X400 platform cube in the rack.
About this task
WARNING The X400 platform cube is heavy and should be installed in the rack by
two people. To avoid personal injury and/or damage to the equipment, do not
attempt to install the X400 platform cube in the rack without a mechanical lift
and/or help from another person.
Procedure
1. If installing the optional chassis retention bracket, insert two cage nuts in the
two rack holes above each rail.
Note: The cage nuts must be installed before installing the X400 platform
cube in the rack.
2. Position the X400 platform cube on the rail.
3. Hold the X400 platform cube rack ears and slide the X400 platform cube into
the rack until the X400 platform cube is seated in place.
4. Tighten the thumbscrews to secure the X400 platform cube.
PowerProtect X400 Appliance Hardware Configuration and Installation Guide
Install X400 cubes in the rack
37