Install The X400 Capacity Cube; Identifying The Rail Kit Components; Install The Rails; Sliding Rail Assembly - Dell EMC PowerProtect X400 Hardware Configuration And Installation Manual

Install X400 cubes in the rack

Install the X400 capacity cube

Identifying the rail kit components

Install the rails

PowerProtect X400 Appliance Hardware Configuration and Installation Guide
30
This section describes how to install the sliding rails for the X400 capacity cube,
secure the rails to the customer-provided rack, and install the X400 capacity cube into
the rack.
The 2U sliding rail assemblies allow the X400 capacity cube to be secured in the rack,
and extended from the rack so that the X400 capacity cube cover can be removed to
access the internal FRUs.
Figure 18 Sliding rail assembly
1. Sliding rail (2)
2. Velcro strap (2)
3. Screw (4)
4. Washer (4)
About this task
The rails are labeled left and right, and cannot be interchanged. The front side of each
rail is labeled Left Front or Right Front when the rail faces the rack front.
Procedure
1. Determine where to mount the X400 capacity cube, and mark the location at
the front and back of the rack.