Keysight Technologies N524 A Series Installation Note page 11

Description of this Upgrade
Tools Required for the Installation
Tools Required for the Installation
Description
T-10 TORX driver - set to 9 in-lbs (1.02 N.m)
T-20 TORX driver - set to 21 in-lbs (2.38 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set to 10 in-lbs (1.13 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set to 21 in-lbs (2.38 N.m)
9 mm nutsetter or open end torque wrench - set to 21 in-lbs) (2.38 N.m)
1/4-in (6 mm) open end wrench
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the front and rear panel bulkhead connectors. On these, use a
9 mm nutsetter or open end torque wrench set to 21 in-lb.
About Installing the Upgrade
Products affected
Installation to be performed by
Estimated installation time
Estimated adjustment time
Estimated full instrument calibration time
Installation Note N5242-90023
All N524xA microwave network analyzers and all N5264A
microwave receivers
Keysight service center, personnel qualified by Keysight, or
customer
4 hours
1.5 hours
4.5 to 8.0 hours
Qty
1
1
1
1
1
1
9