Operating Instructions; Operating The Tool - Signode BXT 10 Operation, Parts And Safety Manual

BUY AT ALLSTRAP (866) 779-2673
6
Wear safety glasses. Stand to one side of the strap when tensioning.
Make sure all bystanders are clear before proceeding.
Fig. 7 Place strap around package
Fig. 8 Slide straps into tool
1
Fig. 9 Strap tensioning
05.07

OPERATING INSTRUCTIONS

WARNING
1
– Insert charged battery (7/1) into strapping tool.
– Place strap round goods to be packaged, so that
the straps lie one above the other on top of
package. The beginning of the strap is under-
neath. Hold the straps with the left hand so that
the strap beginning is approximately 20 cm (8")
ahead of the hand.
– Take the tool in the right hand and lift the rocker
lever (8/1) towards the handle.
1
– Slide the straps, one on top of the other, into the
tool up to the stop.
NOTE:
The strap lead is now approximately 5 cm (2")
beyond the tool.
– Release the rocker lever.
– Press the push button (9/1). The strap is ten-
sioned until the required or pre-selected strap
tension is reached.
– The strap tension can be adjusted on the
operating panel (see Chapter 6.3.2).
– The strap can be re-tensioned at any time.
Releasing strap tension
In order to release the strap tension after the
tensioning process, lift rocker lever (8/1) against
handle.
NOTE:
Tensioning – welding:
The welding may also be started before the strap
has been tensioned. However, the tensioning
button must be pressed briefl y before welding.
9

6.1 OPERATING THE TOOL