Operating Instructions - Signode SLP-38 Operation, Parts And Safety Manual

OPERATING INSTRUCTIONS

Make sure all bystanders are clear before proceeding.
1. STRAP LOADING
Make sure the strap being used is the
proper size for the tool model being used.
Refer to the Specifications section on
page 5 of this manual.
Pass the strap over the top of the package
then bring the lead end around and up.
This will result in creating a TOP STRAP
and a BOTTOM STRAP. They will be
referred to later in these instructions.
2. POSITIONING THE TOOL
Squeeze the tension motor and the
handle together to create an
opening between the feedwheel
and the clutch plug. Grasp the
TOP STRAP and BOTTOM STRAP
together and insert both straps
sideways into the tool between the
feedwheel and the clutch plug.
Allow for the lead end of the strap
to protrude 1" to 2" beyond the
tool base. When the straps are
properly loaded, the sealing
mechanism will be in line with the
strap. Release the tension motor.
Wear safety glasses and gloves.
Always position yourself to one side of the strap.
9
For Parts & Service 1-877-862-6699