Operating Instructions - Signode AM Series Operation, Parts And Safety Manual

OPERATING INSTRUCTIONS

Wear safety glasses which conform to ANSI Standard Z87.1 or EN 166.
Failure to follow the above could result in severe personal injury.
LOADING SEALS
An extension on the seal pad (61) closes the top
strap loading slot as a reminder to add seals. Raise
the seal pad assembly and insert a stack of seals in
the side of the seal magazine. Make sure the seal
stack is pushed all the way in. You may load seals
at any time without waiting for seals to run out,
because you can break a stack and load as many or
as few as you wish.
STRAPPING TIE
1. Encircle the package with the strap and insert
the bottom strap-end under the rocking
gripper. Push it forward until it contacts the
gripper stem. Press the gripper trigger to
actuate the holding gripper.
2. Insert the top strap under the feedwheel and
insert it sideways into the slot of the strap latch.
Pull the excess slack from the strap.
Stand to one side of the strap while tensioning.
Make sure all bystanders are clear before proceeding.
5