Beater Rotation; Refrigerant - Taylor 430 Torque Original Operating Instructions

Beater Rotation

Beater rotation must be clockwise as viewed
looking into the freezing cylinder.
Note: The following
performed by an authorized Taylor service
technician.
To correct rotation on a single--phase unit, change the
leads inside the beater motor. (Follow the diagram
printed on motor.)

Refrigerant

In consideration of our environment, Taylor
proudly uses only earth friendly HFC refrigerants. The
HFC refrigerant used in this unit is R404A. This
refrigerant is generally considered non-toxic and
non-flammable, with an Ozone Depleting Potential
(ODP) of zero (0). However, any gas under pressure
is potentially hazardous and must be handled with
caution.
NEVER fill any refrigerant cylinder completely with
liquid. Filling the cylinder to approximately 80% will
allow for normal expansion.
Use only R134a refrigerant that conforms to
the AHI standard 700 specification. The use of any
other refrigerant may expose users and operators to
unexpected safety hazards.
Model 430 Torque
procedure must be
Refrigerant liquid sprayed onto the skin may
cause serious damage to tissue. Keep eyes and skin
protected. If refrigerant burns should occur, flush
immediately with cold water. If burns are severe, apply
ice packs and contact a physician immediately.
Taylor reminds technicians to be cautious of
government laws regarding refrigerant recovery,
recycling, and reclaiming systems. If you have any
questions regarding these laws, please contact the
factory Service Department.
WARNING:
conjunction with polyolester oils is extremely moisture
absorbent. When opening a refrigeration system, the
maximum time the system is open must not exceed 15
minutes. Cap all open tubing to prevent humid air or
water from being absorbed by the oil.
3
R404A refrigerant used in
120709
To the Installer