Taylor 430 Torque Original Operating Instructions page 24

Section 8
PROBLEM
1. No product being
dispensed.
2. Unit will not operate in the
"AUTO" or "WASH" mode.
3. No compressor operation
in the "AUTO" mode.
4. Product too thick.
Troubleshooting Guide
Troubleshooting Guide
PROBABLE CAUSE
a. Power switch is in the "OFF"
position.
b. Improper mixing of product.
c. Inadequate mix in hopper.
d. Product frozen--up in freezing
cylinder.
e. Unit out on reset.
f. Beater assembly is not
rotating at all or
counterclockwise. Control
switch is not in "AUTO".
g. Unit is unplugged.
h. Tripped circuit breaker or
blown fuse.
a. Unit unplugged at wall
receptacle.
b. Tripped circuit breaker or
blown fuse.
c. Unit out on reset.
a. Beater motor is out on
overload.
b. Condenser dirty A/C.
a. Inadequate mix in hopper.
b. Improper mixing of product.
c. The viscosity adjustment is
set incorrectly.
d. The torque arm is not
installed.
20
REMEDY
a. Place power switch in the
"AUTO" position.
b. Carefully follow directions
for mixing product.
c. Fill hopper with mix.
d. Adjust viscosity adjustment
accordingly.
e. Place power switch in the
"OFF" position. Press the
reset button. Return
control switch to "AUTO".
f. The power switch must be
in "AUTO". If beater is
rotating counterclockwise,
call service technician to
correct rotation.
g. Plug in power cord.
h. Reset circuit breaker or
replace fuse.
a. Plug in power cord.
b. Reset circuit breaker or
replace fuse.
c. Place the power switch in
the "OFF" position. Press
the reset button. Return
control switch to "AUTO".
a. Place control switch in
"OFF" position. Press the
reset button. Return
control switch to "AUTO".
b. Clean condenser monthly.
a. Fill hopper with mix.
b. Carefully follow directions
for mixing product.
c. Adjust the viscosity control.
d. Install the torque arm.
Model 430 Torque
PAGE
REF.
15
-- -- --
16
10
10
1
-- -- --
-- -- --
-- -- --
-- -- --
10
10
18
16
-- -- --
10
13