Sanitizing - Taylor 430 Torque Original Operating Instructions

Step 7
Install the front drip pan. Slide the long drip pan into the
hole in the front panel.
Figure 17
Step 8
Install the front drip tray and splash shield beneath the
door spout.
Figure 18
Step 9
Lay the air/mix feed tube (optional) in the bottom of the
mix hopper.
Figure 19
090114
Operating Procedures

Sanitizing

Step 1
Prepare a pail of an approved 100 PPM sanitizing
solution (examples: 2--1/2 gal. [9.5 liters] of Kay--5R
or 2 gal. [7.6 liters] of Stera--SheenR). USE WARM
WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS.
Step 2
Pour the sanitizing solution into the hopper and allow
it to flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush clean the mix hopper, air/mix feed tube
(optional) and mix inlet hole.
Step 4
Place the power switch in the "WASH" position. This
will agitate the sanitizing solution in the freezing
cylinder. Allow the solution to agitate for five minutes.
14
Figure 20
Figure 21
Model 430 Torque