Table of Contents
Advertisement
GE H
EALTHCARE
D
5141177-100, R
IRECTION
EVISION
Section 4.0
Gantry Considerations
The gantry is mounted on the pallet. Use dolly elevating casters to lift gantry off its base and roll it
into position. See
Door Openings. Clear door openings for moving equipment into building must be 1067 X 2083 mm
(42 X 82 in. ) minimum. 2439 mm (8 ft. ) corridor width is helpful.
Elevator requirements. To move gantry from receiving location to scanning room, consider
elevator capacity and size. By removing side rails and one dolly after gantry is placed in elevator,
gantry width/length and elevator depth requirements are reduced. Contact a representative of
elevator manufacturer if gantry weight exceeds elevator capacity.
Dollies On, Side Rails Removed
Table 7-1 Size of Gantry & Dollies, with and without Side Rails
Minimum hallway and door size for gantry with covers and dollies attached, but side rails removed,
is 101.6 cm (40 in. ).
For alternative lifting arrangements and instructions, contact GE Installation Support Services.
Dollies: Dollies can be purchased for international shipments (B7850LD) or US shipments
(B7850GD) to be used at the customer site. After the system has been removed from the crates,
dollies shipped with international shipments only are not to be shipped back to GE in Milwaukee,
WI, USA, but to be retained to the local GE office or warehouse.
Gantry shipping dimensions are:
14
Figure
7-1.
Figure 7-1 Gantry with dollies
CONFIGURATION
Dollies On, Side Rails On
Dollies Off, Covers Off
2440mm (96 in. ) long, 1370mm (54 in. ) wide, 2180mm (86 in. ) high
Chapter 7 - Delivery and Storage Requirements
B
S
E
RIGHT
PEED
LENGTH
WIDTH
(
)
(
)
CM
IN
CM
IN
281 (111)
129 (51)
281 (111)
100 (39.4)
197 (77)
86 (34)
, E
, E
: P
-I
LITE
DGE
XCEL
RE
NSTALLATION
HEIGHT
WEIGHT
(
)
KG (LB)
CM
IN
200 (79)
2041 (4496)
200 (79)
2013 (4434)
185 (73)
1662 (3660)
Page 119
Advertisement
Table of Contents
