Setting Of Enlargement Or Reduction For Copying; Selecting A Pre-Set Rate - Muratec MFX-1500 Operating Instructions Manual

4.
Press .
ENTER
5. Then, if necessary, press
PAPER SIZE
paper you place document on the
A5R- or B5-sized paper.
Copy Ready Num: 1
T:A4 100%
T:A5 100%
T:A5 100%
T:B5 100%
T:OHP 100%
Note: When you set the transparency film, please select "OHP" mode.
You can use the A4-sized transparency film.
6. If necessary, select desired resolution, contrast, reduction/enlargement rate.
(See "Setting of enlargement or reduction for copying," right column.)
7. Press to begin the copying process.
START
? again to select a same size of recording
or . You can select either A4-, A5-,
ADF FBS
Setting of enlargement or reduction
for copying
Your fax machine is capable of enlargement and reduction when copying.
Note: The copy enlargement and reduction rate setting is available only for copying,
not for faxing.
Important: Copy enlargement is available only for copying using the
available for copying using the
To change the reduction or enlargement rate for copying, either select a pre-set rate or
directly enter a rate.

Selecting a pre-set rate

Either . . .
• Press
to select one of the following fixed enlargement rates.
ENLARGE
100% 115% 122%
115%: B5 → A4
122%: A4 → B4, A5 → B5, A5R → B5R, B5 → A4
141%: B5 → B4, A5 → A4
172%: A5 → B4
. . . or . . .
• Press
to select one of the following fixed reduction rates.
REDUCE
100% 86% 81%
86%: A3 → B4, A4 → B5, A4R → B5R
81%: B4 → A4, B5 → A5, B5R → A5R
70%: A3 → A4, B4 → B5, A4 → A5, A4R → A5R
50%: A3 → A5
Getting started
; it is not
FBS
.
ADF
141% 172% 200%
70% 50%
1.37