Muratec MFX-1500 Operating Instructions Manual page 118

Beyond the basics
Note: If you make a mistake or want to erase characters entered in a previous
setting, press to erase leftward. Or, if you want to change just
CANCEL
one character in the number, press
to move it rightward, to that character and press
Then re-enter until the number is just as you want it.
Now, while you still can see the fax number on the display, press
6.
eight times. The following display appears:
COMMUNICATION OPTIONS
8.F-Code Polling
Comm.Option/Enter
7. Press . The display will show:
ENTER
Enter Sub-Address
_
8. Use the numeric keypad to enter the
(i. e., - sub-address number) you want to poll.
ITU T
For example, here, we've entered 123456:
Enter Sub-Address
123456_
9. Press . The display will show:
ENTER
Enter Password
_
Note: If you know that this sub-address does not have a password, skip to
step 11.
10. Use the numeric keypad to enter the appropriate
there is one; if there's not, you may skip to step 11, as explained in the first
Note, below). In this example, we've entered 654321.
Enter password
654321_
Note: If you make a mistake, press
number.
When the entry is complete, press
11. If you want the transmission to begin immediately every time you press the
key, press again and skip to step 14.
ENTER
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS
2.70
to move the cursor leftward, or
to erase it.
CANCEL
- sub-address for each box
ITU T
- password for the box (if
ITU T
to back up, then enter the correct
CANCEL
.
ENTER
, .
ENTER
12. There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of the
month (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the key.
(For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0
(i. e., 00), and then the time when the fax could perform
the command:
Delayed
Enter Time: 00/17:05
13. Press , .
ENTER ENTER
14. The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key's programming, press
to return your machine to its usual standby mode.
STOP
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.
on the 30th.")
PM
today.")
PM