Clearing Paper Jams - Muratec MFX-1500 Operating Instructions Manual

Just in case ...

Clearing paper jams

We have designed your fax machine to work reliably for years. However, you may
occasionally experience one type or another of paper jam. Here's what to do.
If an original document jams
1. If an original document jams, the display will show:
Document Jam
ContStor Enter/Cancl
If you do wish to continue the operation, press
To abort the operation, press
CANCEL
stored during this operation, and the machine will return to standby mode.
Important: If you wait more than 60 seconds without pressing any key, the
machine will delete from memory all pages stored during this
operation and the machine will return to the standby mode.
Note: If this document is a non-sorting
machine will abort the operation anyway; instead, you'll have to
perform the job again from scratch.
2. The display will show which page (i. e., which page number) is jammed.
To continue scanning from the jammed page forward (keeping in mind the
Note at the end of step 1, above), press
P 2.Reset Document
Press Start
Note: If you wait more than 60 seconds without pressing any key, the
machine will begin to send or copy the document(s) it has.
If you wish to cancel this operation, press
pages from memory and then return to its standby mode.
3.2
and proceed to step 2.
ENTER
. This will delete from memory all pages
job (either copying or faxing), the
ADF
after clearing the jam.
START
. The machine will delete all
STOP
To remove the document:
1.
Open the scanner cover by
holding the scanner cover
release.
Important: Hold the cover
open. It won't
stay open by
itself.
2.
Lift the original document
from the machine.
Note: If you cannot remove
the original document,
open the inner cover as
shown in the diagram,
then remove the
document.
3.
Gently close the scanner cover, making sure both sides are snapped down
securely.
Note: If the original document has become wrinkled or torn, do not re-send it.