Muratec MFX-1500 Operating Instructions Manual page 35

Getting started
8. Press .
START
Your machine will scan the document into memory.
Note: The more "stuff" (or black coverage, to use the fax term) your machine
"sees" on a page, the more slowly the page will feed through as the fax
scans it — especially when you transmit in non-memory mode. Sending
a page in greyscale mode or certain resolution settings makes your
machine (see more detail). The same is true if you set the contrast to
Dark.
While your machine scans the document, the display will show:
919725552009
A4 NextDoc Mem100%
Amount of memory available.
If NextDoc appears, it means the machine is ready to scan
another page (after completing the current scanning job).
If you don't wish to send any more pages, press
clear the NextDoc message; your fax will dial as soon as the
machine finishes scanning.
Document size of document currently being scanned.
9.
When the scanning is done, the display will show:
Start Scan → Next
Tx Start → Start
To send more pages, proceed to step 10.
If the machine has finished scanning all the pages you want to send on this
transmission, press , and skip to step 12.
START
10.
Place the next page, then press
11.
To send any more pages, repeat steps 9–10.
12. Now, everything is up to the machines — yours and the one you're dialling.
When it makes contact, your machine transmits the stored document from
memory.
Note: What if the call fails for some reason? See pages 1.27–1.28.
1.26
Fax number you entered in step 7.
to start scanning.
NEXT
Sending a fax with on-hook dialling or a
handset: manual transmission
Important: Manual transmission available only when you use the
You also can fax a document by dialling using either the monitor speaker (this is
called "on-hook" dialling) or the optional handset. Here's how:
1.
If the machine is already in Fax mode, skip to step 2.
If the machine is in Copy mode, press
2. Insert the document into the
3. Adjust resolution and contrast if necessary.
If these are
OK
Press
RESOLUTION
Press
CONTRAST
to
NEXT
4.
Obtain a dial tone. You can do this by either:
• Activating the monitor speaker (by pressing
... or ...
• Lifting an optional handset.
In either case, the display shows:
** Tel Mode
_
5.
Enter the fax number by using the numeric keypad.
Note: For information on entering one-touch and speed-dial numbers, see
pages 2.11–2.14.
** Tel Mode
919724032009_
Enter access codes along with the number, just as for a regular phone call.
6.
When you hear fax tones from the remote unit, press
Note: If a person answers the phone, tell him or her you're trying to send a
fax. When his/her machine sends you fax tones, then press
7. If you're using the monitor speaker, skip to step 8.
If you're using an optional handset, hang up (after pressing
Note: What if the call fails for some reason? See "Redialling manually," next
page.
/ to change to Fax mode.
COPY FAX
.
ADF
, skip to step 4. Otherwise, as desired:
to change the resolution.
, then press or to change the contrast.
MONITOR
**
**
.
ADF
/
).
CALL
.
START
.
START
).
START