Muratec MFX-1500 Operating Instructions Manual page 117

11. If you want the transmission to begin immediately every time you press the
key, press again and skip to step 14.
ENTER
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS
12.
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of the
month (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the key.
(For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0
(i. e., 00), and then the time when the fax could perform the
command:
Delayed
Enter Time: 00/17:05
13.
Press , .
ENTER ENTER
14. The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key's programming, press
to return your machine to its usual standby mode.
STOP
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.
, .
ENTER
on the 30th.")
PM
today.")
PM
Programming F - Code polling
Note: To erase a programmable one-touch key, refer to page 2.71.
Note: For F-Code polling to work, two things must be true:
• The document which you're polling must exist on the remote machine in
an F-Code box.
• You must know the remote fax's
password number for each box you wish to poll.
To program a F-Code transmitting operation into a programmable one-touch key:
1.
Press , , 1, . The display either shows:
PROGRAM C ENTER
Select Program No.
73:No Number Stored
. . . or indicates a command already is programmed into this key.
If 73 is the key you want to program, skip to step 4. (However, our examples
from here will say "74" rather than "73."
2.
Select the key in which you want to program a command or change a
previously stored command — if necessary, turn the fliptab to see it, as
described earlier — and then press it. Here, we've selected 74.
Select Program No.
74:No Number Stored
3.
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4. Press . The display now shows either:
ENTER
74:Fax Number
_
5.
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The number
can be up to 40 characters in length:
76:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance numbers), press
scroll leftward or to scroll rightward.
Important: Do not press
ENTER
Beyond the basics
- sub-address and (if applicable)
ITU T
74:Fax Number
or
9-5557312_
.
to
2.69