Muratec MFX-1500 Operating Instructions Manual page 32

Using memory transmission
Your fax machine has a great memory! and, because it does, it can finish fax jobs
more quickly than otherwise would be possible.
By automatically scanning your fax document into, then transmitting from, its
memory — rather than transmitting each part of the scan only as quickly as the
receiving fax machine can receive it — your fax machine can hand you back your
original document more rapidly.
Here's a real money saver on long distance fax calls: if you're transmitting to another
memory-equipped Muratec fax machine, your machine will send the document
directly into the other machine's memory and hang up! (The receiving machine then
prints out your message from its memory.) This cuts your actual on-line time to a
minimum.
Better still: set up a delayed command (see pages 2.20–2.22) to send your document
to that other Muratec fax machine after hours, and you'll save two ways on the call:
not only will the call itself be short, but also the line charges will be cheaper!
You can set your fax machine always to transmit from memory as a default.
Note: Whichever choice you make, you can override that choice one transmission at
a time by pressing
MEMORY TRANSMIT
below.) After completing the communication, your fax machine will return to
your desired transmission setting.
Note: Although it's probably best to decide to transmit from memory, be aware that
certain types of documents can quickly exhaust even your machine's large
memory supply. Obviously, documents with large numbers of pages qualify;
so do documents with lots of dark areas, since darker pages create more data
for your fax machine to "remember" and send. When the machine's memory
supply is full, it can transmit only in normal (i. e., non-memory) mode.
Important: When you transmit using the
memory. This choice is available only when you transmit using the
. (However, see the "Important" item,
, your machine always transmits from
FBS
To make memory transmission the default for transmissions from the
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
2. Press ,
PROGRAM
Memory Tx:
Program/Enter
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
3. To change the setting, press
chosen Off.
Memory Tx:
Program/Enter
4. Press to save the setting.
ENTER
Toggling between Fax mode and Copy mode
To toggle (switch between) Fax mode or Copy mode, simply press
The glowing tells you the current machine mode:
LED
Fax mode
.
COPY
ADF
/ to change to Fax mode.
COPY FAX
, 1, 3, .
J ENTER
On
once or twice. In this example, we've
PROGRAM
Off
Copy mode
FAX
COPY FAX
Getting started
:
ADF
/ .
COPY FAX
1.23