Controller Programming - Broaster 2400 Series Service Manual

CONTROLLER PROGRAMMING

Check oil level before
turning cook/filter switch
to COOK.
NORMAL OPERATING MODE
Action: Turn cook/filter switch to
COOK.
Response: Temp Display alternates
between number values for cook tem-
perature, and LO (idle mode). LO will
disappear when oil temperature has
reached cook temperature value.
Time Display will show the set time in
minutes and seconds.
Set Temperature:
Action: Press Cook Temperature But-
ton twice within 5 seconds.
Response: Programming mode has
been entered. Flashing Temp Display
reads "###F." (### = temperature
value ie: 360F)
Action: If desired, press keypad num-
bers to change displayed value. Press
Cook Temperature Button once to
enter new value into memory.
Response: Controller returns to idle
mode.
Set Time:
Action: Press Cook Time Button
twice within 5 seconds.
Response: Programming mode has
been entered. Flashing Time Display
reads "##:##." (##:## = time value ie:
08:00)
Set AUTO COMP (Automatic Time Com-
pensation):
Display Actual Temperature:
Reset Cycle Counter:
Upon the next cycle completion, the dis-
play will begin counting at "01".
Normal operating programming can be
done at any time without affecting presets.
3-2
broaster.com Manual #15460 8/02 Rev 6/16
Action: If desired, press key pad
numbers to change displayed value in
minutes and seconds. Press Cook
Time Button once to enter new value
into memory.
Response: Controller returns to idle
mode.
Action: Press and hold AUTO COMP
Button for 3 seconds.
Response: Green light will toggle on
or off.
Action: Press and hold Temp Button
for 3 seconds.
Response: Temp Display will show
actual oil temperature and will vary as
cooling and heating takes place.
Action: Press Temp Button to return
to set point display.
Action: Press Reset Button twice in 5
seconds.
Response: Display will return to a
setting of "00."
If counter is not reset
before reaching "99".