Smart Touch Controller Tips - Broaster 2400 Service Manual

SMART TOUCH CONTROLLER TIPS

COMPLAINT
Display reads Oil temperature not rising
HEATER FAULT
Display is blank
Display doesn't
respond when
touched
* Probe circuit is open or
Display reads
PROBE FAULT
Display reads HI
TEMP FAULT
Display reads
INTERNAL FAULT
Display reads C1 contactor is stuck in
C1 FAULT
CAUSE
properly
Screen not calibrated
shorted
*Probe wires are
connected in reverse
*Temperature changes
more than 100F in two
seconds
Temp reaches 415F
Internal fault detected
the closed position
broaster.com Manual #17280 1/15 Rev 3/16
1800E
REMEDY
* Call for service
* With unit off, place finger on screen and hold while
turning unit on. Touch the small box in the upper left
corner until it moves to the upper right corner, then touch
it again until it moves to the lower left corner, then touch
it again until it disappears. Controller will reboot.
* Call for service
* Call for service
* Call for service
* Call for service
* Call for service
9-2
1800GH
REMEDY
* Remove anything causing a
draft by the unit (like a fan).
* Turn on the gas valve.
* Call for service
* Call for service
* Call for service
* Call for service
* Call for service