Power On Indicator Light; Solid State Controller - Broaster 2400 Series Service Manual

POWER ON INDICATOR LIGHT

Illuminates when cook/filter switch is turned
to COOK.
Replacement:
1. See ACCESS FOR SERVICE.
2. Disconnect wires.
3. Push down on light fixture (2) located
behind control panel. Slide fixture
toward wire end until amber lens (16) is
free of fixture.
4. Install new light in reverse order. Be
sure all wire connections are secure
and in the original location.

SOLID STATE CONTROLLER

The controller regulates time and tempera-
ture.
Miscellaneous: Remove F/C jumper to
display temperature in Celsius.
Replacement:
Note: Within warranty, controller should be
replaced as a whole: circuit board, trans-
former, speaker and control panel. Out of
warranty, transformer and speaker are
available separately.
Continued:
3-9
broaster.com Manual #15460 8/02 Rev 7/14
1. See ACCESS FOR SERVICE.
2. Remove cook/filter switch.
3. Remove power on indicator light.
4. Disconnect HEATER OUTPUT (N.O.)
wires using needle nose pliers.
5. Disconnect START SWITCH wires
using needle nose pliers.