Operational Lockout; Controller Basic Programming; Normal Operating Mode - Broaster VF3iXP Installation & Operation Manual

OPERATIONAL LOCKOUTS
Indicator lights illuminate to show "Opera-
tion Lockout" conditions that need to be cor-
rected before unit will function.
15. Product Door Indicator Light: Illumi-
nates when the Product Door is open.
16. Access Door Indicator Light: Illumi-
nates when the Access Door is open or
when Access Door Latch is improperly
latched.
17. Element Up Indicator Light: Illuminates
when the heating element is in the
raised position.
18. Air Flow Indicator Light: Illuminates
when the flow of air through the Air Fil-
ter area falls below acceptable level.
NOTE: Replace Air Filter every 3
months.
19. Air Filter Indicator Light: Illuminates
when the air filter is not installed in the
unit.
20. Grease Filter Indicator Light: Illumi-
nates when the grease filter is not
installed in the unit.
21. Hi-Limit Control Indicator Light: Pre-
vents oil temperature from exceeding
475° F. If power to control turns off due
to Hi-Limit Control, this indicator light
will illuminate, press the OFF button
and DO NOT attempt to operate until it
has been serviced by an authorized
Broaster Company representative.
22. Fire System Light: Illuminates when 6
months have passed to indicate semi-
annual maintenence is due on fire sup-
pression system.
CONTROLLER BASIC
PROGRAMMING

NORMAL OPERATING MODE

CAUTION: Check oil level before
pressing the 'ON' button.
Action: Press 'ON' button.
Response: Temp Display alternates
between number values for cook tem-
perature, and LO (idle mode). LO will
disappear when oil temperature has
reached cook temperature value. Time
Display will show the set time in min-
utes and seconds.
Set Temperature:
Action: Press Cook Temperature But-
ton twice within 5 seconds.
Response: Programming mode has
been entered. Flashing Temp Display
reads "###F." (### = temperature
value ie: 360F)
Action: If desired, press keypad num-
bers to change displayed value then
press Cook Temperature Button once
to enter new value into memory.
Response: Controller returns to idle
mode.
5 - 2
Manual #16887 5/08