Table of Contents
Advertisement
This value will remain unless you power off the printer. If you want to retain
this value even after you turn off the power, store it using the Macro
Definition function, which is described later.
Note that you can only change this value immediately after loading paper. If
you feed paper, you cannot change the auto loading value.
Clearing the buffer/AI/ reset
The printer stores received data in a large memory buffer. This creates a
problem when you want to abandon a printing job and restart: the printer may
be holding mote data in its buffer than it has actually printed, and this
unprinted data must be cleared out before restarting. Turning power off is one
way to clear the buffer, but there is another way:
1. Halt the printing program on the computer. If printing stops immediately,
the buffer is clear and the rest of this procedure is unnecessary. If printing
does not stop, continue as follows:
2.
Press the
I
ON LINE
I
button to set the printer off-line. Printing will
now stop, but there may be data remaining in the buffer.
3. Press and hold the I
ON LINE
I button.
4. While pressing the
I
ON LINE
J button down, press and hold the
IFoNT
button. Continue holding these two buttons down. In few
seconds you will hear a beep tone signaling that the buffer has been
cleared.
If you hold these switches more three seconds, you will hear three beep
tones signaling that the printer has been initialized to the power-on
default settings.
5. Release these buttons, make any necessary control panel settings, then
set the printer back on-line.
It is essential to halt the printing program on the computer before you go off-
line. Otherwise, when you go back on-line the computer will start sending
data again and the printer will continue printing, with missing data where the
buffer was cleared.
Selecting the print color
Normally, the printer prints with black even if the color ribbon is installed.
Without the aid of software, you can change the printing color as follows:
1. Press the
I
ON LINE
1 button to set the printer off-line.
2. Press the I]
button and hold it down.
52
-
--
Advertisement
Table of Contents
