Table of Contents
Advertisement
Tractor cover
Clamp lever
Figure 44
Mount the fanfold paper over the tractor units.
9. Now close the tractor covers, again making sure that the paper holes are
aligned with the pins on the tractor units. If they are not aligned properly,
you will have problems with paper feeding, possibly resulting in tearing
and jamming of the paper.
10. Turn on the power using the switch located at the front of the printer. The
printer will beep, indicating that the paper is not yet fully loaded. The
PAPER
indicator will also illuminate to confirm this.
11. Now press the 1 St "tJtG
' I
PARK
button. The paper will be fed and adjusted
past the print head to a position ready for printing.
12. If you want to set the paper to a different position, set the printer off-line
by pressing the 1
ON LINE
1 button, then set the paper by using the
micro-feed function. (For details, refer to Chapter 5.)
13. Close the rear cover and the transparent part of the front cover, then
mount the paper guide in the horizontal position shown in Figure 4-5, so
that it will separate the printed from the unprinted paper.
29
Advertisement
Table of Contents
