Table of Contents
Advertisement
l
Auto On-Line
Set the status just after loaded the paper into the printer.
When the Auto-Online is set
[*ENABLED],
the printer automatically goes
on-line.
When it is
set [DISABLED],
you must press the 1
ON LINE
I button to set
on-line after load the paper.
l
STROBE timing
. .
This switch controls the timing of the interface.
Most computers can communicate with the Normal timing, as the factory-
setting,
[*NORMAL].
If you were not possible to communicate with your computer to the printer,
set this switch to
[REVERSE].
Font menu
The Font menu allows you to set two parameters concerning fonts which will
be automatically selected whenever you turn on the printer.
l
Zero style
This menu tells the printer how to print zero's.
When the
[*NORMAL]
is selected, the printer prints the normal zero; when
it is
[SLASHED],
the slash zero (which is often used in draft mode to prevent
any possible confusion with the letter "0").
l
NLQ Font
.
There are many font styles for NLQ print mode. You can select one of them
as the power-on default by setting this switch.
NOTE:Since there are many fonts you
can
select, the
[OTHER]
option
indicates to select other options on the next line.
Character menu
The Character menu allows you to select the character set which will be
printed.
l
Standard Character Table
If you selected Standard mode, you can set either italic or graphic
characters.
When you select the
[ITALIC]
characters, the character table is the same as
the Epson printers.
When you select
the [*GRAPHICS]
characters, in place of italics you will
get the graphic characters, international characters, and mathematical
symbols of IBM character set #2.
59
Advertisement
Table of Contents
