Table of Contents
Advertisement
INTERFACE CARTRIDGES
You can use the RS-232 Serial Interface with the optional Serial Interface
Cartridge (IS-8XL), or extend the print buffer by installing the .optional
Buffered Parallel Interface Cartridge (IP-128XL), instead of the Standard
Interface Cartridge.
If you want to use the Serial Interface Cartridge, set the DIP switches on the
board before install it to the printer.
1. Turn off the power switch and disconnect the power cord from the power
-
source.
2. Disconnect the interface cable if attached.
,
-
3. Compress the projected parts on the right and left, and pull the Standard
Interface Cartridge to remove it from the printer.
-
Flgurr 312. Remove the Standard Interface Cartridge from the printer.
4. Insert the optional Interface Cartridge securely into place. If it is not fully
inserted, the printer will not properly print.
5. Connect the interface cable to the connector.
NOTE : Store the removed Interface Cartridge in a safe place.
-
22
-
Advertisement
Table of Contents
