Table of Contents
Advertisement
Paper menu
This menu allows you to set up various handling options of paper.
l
Paper-out detector
When this switch is [DISABLED] the printer ignores the paper-out detector
and prints down to (and beyond) the bottom edge. Otherwise leave it
PENABLED].
l
Multi-part mode
Youcanuseupto3-plypaperwithnonnalmode,
PDISABLED]. Ifyouwant
to print on 4-ply or S-ply paper, set the Multi-part mode to [ENABLED].
9 Automatic Sheet Feeder
In order to use the optional Automatic Sheet Feeder, set this switch to the
related position. [SINGLE] for single-bin ASF, [DUAL-l] for the front bin
of Dual-bin ASF, and [DUAL-21 for the rear bin of the Dual-bin ASF.
If you do not use the optional Automatic Sheet Feeder, leave this [*OFF].
. Auto loading amount for each paper type
Sets the first line position on the each paper type.
&
Forms menu
c
i
The Forms menu allows you to set various options associated with paper
handling.
l
Tear-Off function
L.
.
You can select the Tear Off function with this switch [ENABLED].
When using fanfold paper, the Tear Off function allows you to tear off one
sheet of paper without fully advancing the following sheet.
l
Skip-over-perforation
L
c.
L.
You can select the Skip-over-perforation with this switch [ENABLED].
It is recommended to skip close to the perforation of fanfold forms to get
good print quality.
Ifyoucannotsetthisfunctionwithyoursoftware,setthisswitch[ENABLED].
The printer automatically skips the perforations.
l
Auto Line Feed with CR
Ic.
i.
L.
If you set this switch [*DISABLED], a separate line-feed code is required
from your computer to obtain a line feed.
If you set this switch [ENABLED], the printer performs both a carriage
return and line feed each time it receives a carriage-return code.
Most computer systems send a line feed code, or both a carriage return and
line feed, at the end of each line, so this switch should be left [*DISABLED].
L
61
Advertisement
Table of Contents
