Table of Contents
Advertisement
Printing
on fanfold
paper
Two useful features of the LC24-30 Colour that facilitate
the use of continuous
stationery are paper parking (fan-
fold paper can remain installed in the printer while you
temporarily
switch to printing on single sheets), and the
tear-off function (you can remove printed output with-
out losing the current paper position). These are
described in the following sections.
You can also use the same paper position adjustment
techniques,
such as line feed and form feed, that you
use with single cut sheets. These are described on
page 59 of Chapter 4.
You can also set a new auto load position (the distance
from the top of each new page at which the printer auto-
matically
starts printing) specifically
for fanfold paper.
This is independent
of the cut sheet auto load position.
Both auto load positions can be saved as part of a
macro, so that you do not have to reset them each time
you switch the printer off and on again.
Setting the auto load position is described on page 60 of
Chapter 4. Saving macro settings is described on
page 62 of Chapter 4.
When printing on continuous
stationery,
take care not
to print too close to the perforations
which separate
each sheet. This can cause poor quality output, paper
misalignment
or paper jamming.
The recommended
printable area for fanfold paper is shown in the following
diagram.
Page 79
Advertisement
Table of Contents
