Printing On Fanfold Paper - Star Micronics LC-7211 User Manual

Fanfold paper
Papier continu
Endlospapier
Modulo continuo
4 mm (0.16")
18 mm
(0.7")
Perforation
Ligne prédécoupée
4 mm (0.16")
4 mm (0.16")
Perforation
Perforazione
Bottom of Form
6 mm (0.25")
Fin de la page
Unterer Druckrand
Fine della pagina
17
Cut-sheet paper
Feuilles séparées
Einzelblatt
Fogli singoli
4 mm (0.16")
18 mm
(0.7")
5 mm 5 mm (0.2")
(0.2")
6.35 mm
(0.25")min.
6 mm (0.25")
25.4 mm
(1")
Labels
Etiquettes
Etiketten
Etichette
Perforation
2.54 mm (0.1") min.
C
C C
C
Label
C : 2.54 mm (0.1") min.
6.35 mm
(0.25")min.
Envelope
Enveloppe
Umschlag
Busta
12.7 mm (0.5")
25.4 mm (1")
12.7 mm (0.5")
Open the covers of both tractors and align the
paper so that the pins on the tractors are inserted
into the holes of the paper.
Close the tractor covers. At this point you can
make final adjustments to the paper position by
releasing the gray levers and moving the tractors.
The paper should lie flat with no buckling or
bulging (tractors too close) or no stretching or
elongation of the holes (tractors too far apart).
After making these adjustments, be sure that you
re-lock the tractors by pushing the gray levers
back into their original positions.
Plug the printer back into its AC power source.
The printer will beep a number of times to
indicate that paper is not loaded.
Press the control panel's LF button and the paper
will feed to the starting position.

Printing on fanfold paper

When printing on fanfold paper, take care not to print
too close to the perforations that separate each sheet.
The following shows the recommended print area for
fanfold paper, cut-sheet paper, labels and envelope.