Table of Contents
Advertisement
Unless you have altered the setting, the pitch is set to
10 characters
per inch.
You can also select character pitch from software appli-
cations programs.
Consult the application's
manual for
details.
Preventing
software
font selection
To prevent the font selection from being altered by a
software application
and to ensure that selections can
be made from the control panel only, power up the
printer while holding down the (FONT] key. The printer
will sound a very short beep as it comes on.
Now you can put the printer in not-ready
mode and
select a font. Put the printer back in ready mode again,
and begin printing. From now on, the font selection will
not be affected by any commands
received from your
computer.
To enable software font selection again, turn the printer
off and on again.
Page 54
Advertisement
Table of Contents
