Table of Contents
Advertisement
.
Carefully position the ribbon between the print head
and the print head shield as shown.
Print head shield
bon
Print head
.
Push down gently but firmly on the cartridge to
make sure that it is properly in place. You should be
able to feel a small amount of play (about 1 / 10" -
2.5mm) in the cartridge as you press down on it.
.
Check that the ribbon is properly in place between
the print head and print head shield. Turn the car-
tridge's tension knob clockwise again to take up any
remaining
slack.
Note:
It is important
to make sure that the ribbon is properly posi-
tioned between the print head and print head shield. Other-
wise, the quality of printed output will be poor and the ribbon
may get damaged.
Page
11
Advertisement
Table of Contents
