Table of Contents
Advertisement
Similarly, if only the middle light or bottom light is on,
Courier or Script is selected.
If two lights are on, the font whose name is between the
two lights is the selected font. For example, if the lower
two lights are on, Prestige is the selected font.
Micro Feed
ALT
0
Macro
A
Zoom
a
FF
Prestige typeface selected
Similarly, if the top two lights are on, Sanserif is
selected.
If none of the lights is on, the draft font is selected.
To select a font for printing, use the following steps:
.
First put the printer in not-ready mode by pressing
the (READY] key.
.
Keep pressing the (FONT] key until the lights show
the desired font is selected.
.
Press the (READY) key again to confirm your selection
and put the printer back in ready mode.
To select fonts using your software application,
consult
the application's
manual.
You can also prevent your software from making font
selections,
so that font selection is controlled completely
from the control panel. This is described on page 54 of
Chapter 4.
Page 31
Advertisement
Table of Contents
