Printing On Fanfold Paper; Parking Fanfold Paper - Star Micronics LC-6211 User Manual

Dot matrix printer

Table of Contents

Printer Setup

Printing on fanfold paper

When printing on fanfold paper, take care not to print too close to the

perforations that separate each sheet. The following shows the recommended

print area for fanfold paper and cut-sheet paper.

18 mm

(0.7")

Perforation

Bottom of

Form

It is not necessary to remove fanfold paper currently loaded in the printer in

order to print on cut-sheet paper fed by hand. Instead, simply use the following

procedure to park the fanfold paper.

Tear off the paper at a perforation so there is no more than half a page

sticking out of the front cover of the printer.

If necessary, you can press the control panel's ON LINE button to put the

printer on-line. and then use the SET/EJECT/PARK button to feed the

paper until a perforation is just past the front cover.

Press the control panel's ON LINE button to put the printer off-line.

Press the control panel's SET/EJECT/PARK button. The printer

automatically reverse feeds the fanfold paper until it is no longer in contact

with the platen.

Fanfold paper

4 mm (0.16")

6 mm (0.25")

Cut-sheet paper