Table of Contents
Advertisement
LCD SCREEN
Using the Machine Settings Key
Touch
to change the default machine settings (needle
stop position, embroidery speed, opening display, etc.). To
display the different settings screens, touch
settings",
for "General settings",
settings" or
for "Wireless LAN settings".
Memo
• Touch
or
screen.
Sewing Settings
20
for "Sewing
for "Embroidery
to display a different settings
1
2
3
4
5
6
7
8
G
H
9
0
A
B
C
D
E
F
1 Select whether to use the sewing speed controller to
determine the zigzag width (page 75).
When a straight stitch is selected, the sewing speed
controller can be used to change the needle position.
2 Make adjustments to character or decorative stitch
patterns (page 95).
3 Adjust the presser foot height. Select the height of the
presser foot when the presser foot is raised.
4 Adjust the presser foot pressure. The higher the number,
the greater the pressure will be. Set the pressure at [3]
for normal sewing.
5 Adjust the amount of fabric feeding of the compact dual
feed foot (page 47).
6 Select whether [1-01 Straight stitch (Left)] or [1-03
Straight stitch (Middle)] is the utility stitch that is
automatically selected when the machine is turned on.
7 Select whether utility stitches
are displayed first in the stitch selection screen.
8 You can activate this setting after connecting the multi-
function foot controller (Included with Some Models).
(These settings appear when the multi-function foot
controller is connected to the machine.) (page 51)
9 Select the height of the presser foot when sewing is
stopped when the pivot setting is selected (page 61).
0 Select the height of the presser foot when the machine is
set to free motion sewing mode (page 76).
A When set to [ON], the thickness of the fabric is
automatically detected by an internal sensor while
sewing. This enables the fabric to be fed smoothly.
(page 62, page 65)
B When set to [ON], reinforcement stitches are sewn at the
beginning and/or end of sewing for a reinforcement
stitch pattern, even when
pressed (page 55).
C Adjust the guideline marker position and brightness
(page 61).
D Select whether to lower the presser foot automatically
before starting sewing. (page 57)
E Select whether to raise the presser foot automatically
when stopping sewing. (page 57)
F Select whether touching
automatically lowers the presser foot before cutting the
thread. The presser foot will be raised after the thread is
cut. (page 57)
G You can save the current settings screen image in a USB
media by touching this key when the USB media is
inserted into the USB port. The files are saved in a folder
labeled [bPocket].
H Reset settings on this page to original default. Some
settings are not reset.
or quilting stitches
(Reverse stitch button) is
(Thread cutter button)
Advertisement
Table of Contents
