Operation; General Operating Instructions; Initial Operation; Operating The Cooktop - bora PKT11 Operating And Installation Instructions

6

Operation

Observe all safety and warning information during
X X
operation (see the Safety section).
INFO The cooktop must only be operated with the
stainless steel grease filter installed (see the
cooktop extractor operating instructions).
INFO Clean the grilling zone before using
the cooktop for the first time (see the
Cleaning section).
INFO Preheat the grilling zone for 5 minutes prior to
each use.
INFO Noises may be generated when the grill plate is
heating up or cooling down. This is normal.
INFO A cooling fan has been installed in the Tepan
stainless steel grill. This ensures a long service life
for the electronics and enables the surface of the
grill to cool down quickly. Several measures have
been taken to keep the noise to a minimum but it
cannot be completely eliminated.
INFO The fan has an after-run period at the end of the
grilling session or after cleaning. This after-run is
restricted to a maximum of 20 minutes.
INFO The grill plate can bulge during use.
INFO When grilling or heating up the cooktop using a
high power level, the grill plate can turn slightly
brown.
6.1

General operating instructions

The cooktop is operated using the control knobs.
Each grilling zone has its own control knob. The left knob
controls the front grilling zone, the right knob controls the
rear grilling zone.
There are 9 power levels, one power setting and several
functions available for each grilling zone.
www.bora.com
t
P
9
8
7
Fig. 6.1 Selector ring functions
Selector ring position Function
Switch off
0
Cleaning function and further
c
temperature levels
Power levels
1 - 9
Power setting
P
Timer function
t
Tab. 6.1 Selector ring positions
6.2

Initial operation

Heat the grill plate to 220°C for approx. 25 minutes
X X
before using it for the first time (= power level 8 for
both grilling zones).
INFO Unpleasant odours may be generated during this
process.
6.3

Operating the cooktop

6.3.1 Switching on the grilling zone

Fig. 6.2 Switching on the grilling zone
Turn the selector ring from the 12 o'clock position to a
X X
power level.
Operation
0
c
1
2
3
4
5
6
EN
23