Table of Contents
Advertisement
The appliance must be suitable for the regional
voltage and frequency.
Check the information on the identification plate
X
X
and in the event of deviations, do not connect the
appliance.
Conduct all work extremely attentively and
X
X
conscientiously.
Do not connect the appliance to the mains until
X
X
the duct system has been installed or the
recirculation filter has been fitted.
Only use the connection cables supplied. Where
X
X
necessary these are included in the scope of
delivery.
Do not use the appliance until installation is
X
X
complete. This is the only way to ensure safe
operation.
DANGER!
ÿ
Risk of electric shock from damaged appliance
A damaged appliance can cause an electric shock.
Check the appliance for visible damage prior to
X
X
installation.
Do not install or connect any damaged
X
X
appliances.
Do not operate any damaged appliances.
X
X
CAUTION!
Risk of burning from control knobs that are
not positioned optimally.
If the control knobs are not installed in a suitable
place, during operation there is a risk of sustaining
burns from the cooktop surface.
Only install the control knobs in a suitable place,
X
X
which is practical and safe.
www.bora.com
2.4.1 Safety instructions for cooktop
installation
DANGER!
ÿ
Risk of electric shock from incorrect mains
connection
Connecting the appliance to the mains incorrectly
poses a risk of electric shock.
Make sure that the appliance has a fixed
X
X
connection to the mains voltage.
Make sure that the appliance is connected to a
X
X
properly installed protective conductor system.
Make sure that technical equipment is provided
X
X
to enable all of the appliance's poles to be
disconnected from the mains with a contact
opening width of at least 3 mm (LS switch and
automatic circuit breakers, fuses, contactor).
DANGER!
ÿ
Risk of electric shock from damaged power
supply cable
If the power supply cable is damaged (e.g. during
installation or by coming into contact with hot
cooking surfaces), this can cause an (lethal)
electric shock.
Make sure that the power supply cable does not
X
X
become trapped or damaged.
Make sure that the power supply cable does not
X
X
come into contact with hot cooking surfaces.
2.5
Safety instructions – operation
Make sure that the base of the cookware as well
X
X
as the appliance surfaces are clean and dry.
Always lift (do not drag) cookware to prevent
X
X
scratching and abrasion on the appliance surface.
Do not use the appliance as a storage surface.
X
X
Switch off the appliance after use.
X
X
Safety
EN
7
Advertisement
Table of Contents
