Installation Rotated By 180; Sealing The Cooktop; Establishing Communication - bora PKT11 Operating And Installation Instructions

Installation
EN
2 1
4
Fig. 5.14 Mounting brackets
[1]
Mounting bracket
[2] Washer
[3]
Screw
[4]
Screw (60 mm)
Fasten the cooktop using the mounting brackets [1].
X X
Tighten the mounting brackets with the screws [3] and
X X
[4] using the washer [2] with max. 2 Nm.
Verify that the alignment is correct.
X X
Once all of the installation work is complete, seal the
X X
devices with black, heat-resistant silicone sealant.
5.5.3 Installation rotated by 180°
Rotate the cooktop 180°.
X X
For the installation, proceed as described above.
X X
Change the installation direction in the configuration
X X
menu (see Configuration menu).
INFO If installation is rotated by 180°, then the
connections for the control knobs and the
extraction system are at the front.
INFO Cables of sufficient length are provided.
18
2
3

5.5.4 Sealing the cooktop

Make sure that no silicone sealant gets under the
X X
cooktop.
1
Fig. 5.15 Silicone sealant for flush installation
[1]
black, heat-resistant silicone sealant
1
Fig. 5.16 Silicone sealant for surface mounting
[1]
black, heat-resistant silicone sealant

5.5.5 Establishing communication

The appliance components are linked by the ribbon cable
provided.
Create the connection between the cooktop and the
X X
control knobs.
Create the connection between the cooktop and the
X X
cooktop extractor.
Cooking zone connection
INFO According to the default settings, the left control
knob operates the front cooking zone and the
right control knob operates the rear cooking zone.
www.bora.com