Seat Post: - Exerpeutic EXERWORK 1000 Owner's Manual

ASSEMBLY
TOOL
5mm Allen Wrench With
Phillips Screwdriver 1 PC
STEP 3
3A. Adjusting Seat Before Installing It: The Seat (6) has 2 sets of adjustment holes. It is
recommended that users between 5'1" – 5'6" use the holes towards the rear of the Seat (6). It is
recommended that users between 5'7" – 6'3" use the holes towards the front of the Seat (6).
3B. Installing The Seat To The Seat Post: Align the bolt holes on the underside of the Seat (6)
with the holes on the plate at the top of the Seat Post (5), then secure them together using three
Flat Washers (33), three Spring Washers (102), and three Hexagon Socket Bolts (58). Tighten
the Bolts (58) with the 5mm Allen Wrench provided.
3C. Installing The Seat Post & The Connection Wires: Connect the Connection Wire A (79)
from the Seat Post (5) to the Connection Wire B (99) from the Front Frame (2) as shown in
Figure D. Insert the Seat Post (5) into the Seat Post Plastic Bushing (12) while being careful to
insert the wires without pinching them. Install the Seat Adjustment Knob (14) by turning it
CLOCKWISE, making sure that the Seat Adjustment Knob (14) catches one of the height
adjustment holes of the Seat Post (5).
HARDWARE PACK
(102) Spring Washer
(58) Hexagon Socket
(33) Flat Washer
3 PCS
3 PCS
3 PCS
13