Seat Post ( - Exerpeutic WorkFit Owner's Manual

ASSEMBLY
Tool:
5mm Allen Wrench
With Phillips Screwdriver
Step 3. Seat Installation
The Seat (6) has 2 sets of adjustment holes. It is recommended that users between
5'1" – 5'6" use the holes towards the rear of the Seat (6). It is recommended that
users between 5'7" to 6'3" use the holes towards the front of the Seat (6).
Align the bolt holes on the underside of the Seat (6) with the holes on the top of the Seat
Post (5), then attach the seat and the post using three Flat Washers (33), three Spring
Washers (102), and three Hexagon Socket Bolts (58). Tighten the bolts with the 5mm
Allen Wrench provided.
Connnect the Connection Wire A (79) from the Seat Post (5) to the Connection Wire B
(99) from the Front Frame (2) as shown in Fig. AA-4. Insert the Seat Post (5) into the Seat
Post Plastic Bushing (12) while being careful to insert the wires without pinching them.
Install the Seat Adjustment Knob (14) by turning it clockwise, making sure that the Seat
Adjustment Knob (14) catches one of the height adjustment holes of the Seat Post (5).
Hardware:
(33) Flat Washer (58) Hexagon Socket
(102) Spring Washer
3 PCS 3 PCS
3 PCS
11