User C-Card; User C-Card Menu; Formatting The User C-Card - Standard Horizon CP500 Owner's Manual

11. USER C-CARD

The Optional C-MAP User C-CARD is used to back up Marks, Routes, and Tracks stored
in your GPS Chart Plotter's memory. The User C-CARD is similar to a back up disk used
with a PC, in case you have to clear your GPS Chart Plotter's memory, or if you would like
to transfer Waypoint, Track and Route information from one STANDARD HORIZON GPS
Chart Plotter to another.
11.0

USER C-CARD MENU

C-MAP offers a special card that may be used to backup the User Points and Tracks the
you have created in the GPS Chart Plotter. This optional card is similar to using a floppy disk
on a PC to backup your files or to transfer the information that you have stored to a friends
GPS Chart Plotter. The information shown below will assist you to transfer the User Points,
Routes and Track history to the optional User C-CARD.
To open the User C-CARD page:
1. Press [MENU] twice. Move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight USER C-CARD and press [ENT].

11.0.0 Formatting the User C-CARD

1. Press [MENU] twice. Move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight USER C-CARD and press [ENT]. A screen will
appear.
3. Move the ShuttlePoint knob to highlight FORMAT and press [ENT].
4. A popup Warning window will to confirm you want to format the User C-CARD.
5. Select YES and press [ENT] to confirm (select NO otherwise). The format of User
C-CARD must be done before using a new User C-CARD: this operation prepares the
User C-CARD to receive and store information.
Formatting permanently erases all files previously saved on the User C-CARD.
CP500
Figure 11.0 - User C-CARD Menu
NOTE
Page 59