Transferring The Project To The Cpu Unit - Omron NJ Series Startup Manual

Checking the Program
Check the program that you created.
If there are any errors, correct them.
1
Execute Check All Programs.
The results of the program check are displayed on the Build Tab Page.
If there are any errors, correct them.
4-3-4

Transferring the Project to the CPU Unit

Use the procedure described in 3-6 Transferring the Project to the CPU Unit to transfer the corrected
project to the CPU Unit.
Remain in PROGRAM mode at this time.
NJ-series Startup Guide for Motion Control (W514)
4 Adding an Axis to the Servo System
Useful Function
Double-click any error line to
jump to the rung where the
error was detected.
4
4-19